Rosewill RC200 Manual do Utilizador descarregar pdf (Página 25)

ULTRA ATA/133 PCI RAID Card RC200 User Manual

7. Press Enter to continue and follow on-screen instructions to complete Windows NT 4.0

installation.

＊

For Existing Windows® NT 4.0 Installation

1. Setup the RAID Array prior to driver installation.

2. Install the board and boot up Windows® NT 4.0

3. Double click My Computer/Control Panel/SCSI Adapters, then click Drivers tab.

4. Click Add… then Have Disk…

5. Insert the driver CD, type D:\RC-200\raid (Note: “D:\” represents the drive letter

assigned to the CD-ROM drive you are using. If D is not letter of your CD-ROM drive,

substitute D with the correct drive letter), then click OK

6. Highlight Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller and click OK.

7. Click OK, restart Windows NT 4.0 to complete driver installation.

＊

To Verify Windows® NT 4.0 Installation

1. Double click My Computer/Control Panel/SCSI Adapters.

2. Highlight Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller from SCSI

Adapters listing and click Properties. A message this device is working properly is

displayed in the dialog box, the driver has been correctly installed.

For Windows® 2000

＊

For New Windows® 2000 Installation

A new installation requires a floppy disk for the driver installation. To make this floppy disk,

1 2 ... 20 21 22 23 24 25 26 27 28

Sem comentários

Rosewill RC200 Manual do Utilizador Página 25