Rosewill RCX-Z4 Manual do Utilizador

user manualCOOLER RCX-Z4

Place the cooler onto the four screws, secure the cooler with four more collars .9user manualCOOLER RCX-Z4Screw the fan onto the heatsink using t

Connect the fan cable with 3 pinconnector to the Fan ControllerCable.10user manualCOOLER RCX-Z4Connect the 3-pin connector of the Y fan cable assigned

Connect the power cable to the speed control and to the PSU 4-pin connector.11user manualCOOLER RCX-Z4Connect the 3-pin connector with theyellow / red

www.rosewill.com

1user manualCOOLER RCX-Z4Improper Installation will result in damage to the processor.Never switch on the computer system until the fan is connected o

AX 5BX 5CX 1Installation ComponentsDX 2EX 2FX 1GX 8HX 2IX 2JX 4KX 6LX 1MX 4NX 4OX 22user manualCOOLER RCX-Z4

AMD K8 / AM2 Installation1Remove the retention module from the motherboard by removing the screws.Keep the original motherboardbackplate as it is. 2NO

Stick the protective insulated film onto the back of the heatsink retention brackets.34OApply the proper amount of thermal compound on the CPU surface,

Place the RCX-Z4 on the top of theCPU, align two holes ( shown in red as the picture below ) of heatsink retention bracket with theMotherboard holes.U

Remove the fan from the sink byunscrewing the four black screws.Take off the pre-attached pair ofK8-AM2 heatsink retention bracket; keep the four scre

Place the screws through thebackplate into the head thread of the screws , make sure the correct four holes are used, as shown in the

Secure the backplate onto themotherboard by using the four collars nuts . Turn these down onto the insulation washer, do not tighten one first, w