Rosewill WIRELESS N ADAPTER RNX-N150UBE Guia do Utilizador descarregar pdf (Página 20)

CHAPTER 2: GETTING STARTED

groov Box User’s Guide

controller, OPC UA server, or Modbus device is on a different network than your computer,

connect ETH0 to your computer's network and ETH1 to the other network.

If you are using both ETH0 and ETH1, make sure they have IP addresses on different subnets. In

some situations, this may require configuring a static IP address. Otherwise there may be

communication errors. For more information, see “Assigning a Static IP Address” on page 29.

For detailed information on setting up your network and setting up communications over the

Internet, see form 1796, the Guide to Networking Opto 22 Products.

Step 5. Connect the Power Supply

Your groov Box requires a power supply with an output of 8–36 VDC, 24 VDC @ 500 mA. You can use

the power supply that comes with the groov Box, or provide your own. In either case, we

recommend using a UPS (uninterruptible power supply) for backup power and surge protection.

If you are using the power supply that came with the groov Box, do the following:

Plug the small connector on the power supply into the power terminal on the bottom of the groov

Box, and tighten the screws. Plug the other end into a standard 120 or 240 VAC outlet.

If you are using your own power supply, do the following:

a. With the power supply off or unplugged, connect the + (positive) lead from the power supply

(normally red) to the + (positive) terminal on the power connector.

CAUTION: Reversing wire polarity may cause damage to your groov Box. This damage is not covered

by Opto 22’s warranty. If you are not certain about the polarity of the wires on your power supply,

check with a meter.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 82 83

Sem comentários

Rosewill WIRELESS N ADAPTER RNX-N150UBE Guia do Utilizador Página 20